About Me
Thursday, July 9, 2009
Day-of Coordination
I only coordinated the wedding ceromony because their reception venue already had a coordinator that they had to pay for. Thanks Christi and Dan for letting me be part of your special day! Congrats!
Wednesday, July 8, 2009
Thank you Card Idea
Friday, June 5, 2009
Erica's Lingerie Shower
Friday, May 29, 2009
Graduation Candy Pops
Monday, April 13, 2009
DIY- Homemade Boutonnieres
Leave the tough stuff to your professional florist, but if you want to add a handcrafted touch, try making the boutonniere.
I suggest using a hardy flower with a big head such as a rose or miniature calla lily; they can survive being handled. You can make a boutonniere the day before the event, and be sure to get extra flowers for practice.
Here's a step-by-step guide on do-it-yourself boutonnieres.
Step 1: Selecting & Preparing the Bundles of Blooms
Pick your bundles of bouquets.
Remove excess foliage and thorns, and pull off damaged petals.
Fill a sink or bucket with water, and holding the stems underwater, use the stem cutter or knife to cut the stems at an angle about two inches from the bottom.
Allow the flowers to drink for a few seconds with the stem ends underwater, then place the stems in a bucket filled halfway with cool water until you are ready to use them.
Step 2: Choosing & Preparing Particular Flowers
Choose a particular stem and/or flower for the boutonniere.
Use a stem cutter or sharp knife to cut the stem to a length of approximately three inches.
Create a bed for the flower: Take an ivy leaf, fern frond, or other bit of greenery and place it behind the flower.
Place a six-inch piece of wire behind the stems.
STEP 3: Crafting the Boutonniere
Prepare the stems: Starting from the top of the stems, begin to wrap floral tape down the stems in a spiral to secure them together; wrap until about 3/4 of an inch is covered.
Trim away the excess stem and continue to wrap floral tape around the wire about three inches down, then wrap the tape back up toward the flower head.
Once you're back at the top, wrap tape around several times to be sure it's secure.
Trim the excess tape.
STEP 4: Securing the Boutonniere
Finish the boutonniere stem: Trim the wired and wrapped stem so the total length is about 1 1/2 inches.
Curl the end around a pencil point and pinch the tip to finish it.
Attach a ribbon bow (if you like).
Depending on the weight of the boutonniere, insert one or two pearl-tipped pins into the stem to use later for attaching it to the lapel.
The boutonniere is now complete! Mist it with water and place it in a resealable plastic sandwich bag (blow a puff of breath into the bag before you seal it to provide airspace around the boutonniere). You can place up to two boutonnieres in the same bag.
For more info on DIY advice check out www.theknot.com
Adapted from The Knot Book of Wedding Flowers (Chronicle Books, 2002).